Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Posting Permissions
CISCO ASA5505-BUN-K9 SECURITY FIREWALL UPGRADE ASA5505
$59.90
Fortinet FortiGate FG-60D Firewall Security Appliance with Power Supply
$65.00
Palo Alto Networks PA-200 Firewall Security Appliance
$36.89
Check Point T-110 Security Appliance Firewall
$49.00
Palo Alto Networks PA-200 Firewall Security Appliance w/ AC Adapter
$69.99
Fortinet FortiWiFi FWF-60D Wireless WiFi VPN Firewall Router Security Appliance
$70.00
SonicWall TZ300 Network Security Firewall with Power Cord
$49.95
Genuine Fortinet Fortigate FG-60D Firewall Security Appliance Fortigate 60D
$34.95
ASA5512-X CISCO ASA 5512-X ADAPTIVE NETWORK SECURITY/FIREWALL APPLIANCE
$69.00
Barracuda Gigabit Rackmount PFsense Firewall Intel G3900a
$174.99
Reply With Quote