Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco SG110 8 Port Gigabit Ethernet Switch SG110D-08-BR
$39.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco SG110 5 Port Gigabit Ethernet Switch SG110D-05-AU
$40.00
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$18.99
New Linksys SE3005 5-port Gigabit Ethernet Switch
$15.99
NETGEAR 5-Port Gigabit Ethernet Unmanaged Switch (GS305) - NEW IN BOX
$18.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$143.32
Cisco Small Business SG200-26 26 Port Smart Gigabit Ethernet Network Switch
$43.95