Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco WS-C3560-48PS-S 48-Port Managed Gigabit PoE Switch
$56.00
Cisco 24-Port Managed Gigabit Switch WS-C3750G-24TS-S
$49.99
Cisco Catalyst 3650 48-Port Managed PoE+ Gigabit Switch WS-C3650-48FS-E
$49.99
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Netgear Prosafe Plus JGS524PE 24 Port Gigabit Switch 12 Port PoE JGS524PE-100NAS
$129.98
HP JG937A Flexnetwork 5130-48G PoE+ 48-Port Gigabit Network Switch
$65.95