Hi,
I think I may have messed up my knoppix USB, because I get a boot error when I try and boot from it. I have another USB I can use. But I cannot access the files that were on the one that does not boot even
if I put in the 'bad' USB when booting with the good one.
Can I safely 'Install knoppix to disk' from that does work to the one that doesn't without losing the data and files I had?
Thanks!
Huge Unisys/UniVAC MAINFRAME HARD DISK DRIVE, 1983, with giant foam clamshell
$499.00
IBM 360/50 Mainframe Console Panel
$15000.00
IMSAI 8080 Vintage Computer fully functional
$3500.00
Vintage Electronic Soviet Mechanical Mainframe EVM Keyboard for ES USSR 1980's
$349.99
LOT of 5 - Vintage mainframe computer panel boards - scrap, art projects
$25.00
IBM Z15-T02 Mainframe (8562-T02) - Complete B02 Rack Config
$86999.00
NMB Vintage Mechanical Keyboard RT6655TW Mainframe Keyboard
$12.99
Intel SBC 660 Chassis iSBC Vintage Computer w/ Some Boards AS-IS System 80
$650.00
2 Piece Gamry Instruments PCI4G Controller & 300/750 Potentiostat Series G Board
$199.99
DCA 003088 Rev. A MacIRMA NuBus I/O Card - 3270 Mainframe Emulation
$59.00