Hi,
I think I may have messed up my knoppix USB, because I get a boot error when I try and boot from it. I have another USB I can use. But I cannot access the files that were on the one that does not boot even
if I put in the 'bad' USB when booting with the good one.
Can I safely 'Install knoppix to disk' from that does work to the one that doesn't without losing the data and files I had?
Thanks!
Cisco QSFP-100G-LR4-S 100GBASE-LR4 QSFP28, 1310nm, 10km, LC, SMF
$335.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Silicom (PE210G2SPI9A-XR) 10Gb Dual Port SFP+ PCIe Ethernet Adapter Low Profile
$19.99
Cisco SFP-10G-BX40D-I 10GBASE-BX-D BiDi SFP+, 1330nm-TX/1270nm-RX, 40km, LC, SMF
$59.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Genuine Cisco GLC-TE 30-1475-01 V01 1000BASE-T SFP COPPER RJ-45 100M TRANSCEIVER
$11.90
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95