I've been looking for a way to get Knoppix to work on my Fujitsu Lifebook P-2040 which uses a Transmeta Crusoe processor. The boot process would freeze when loading the ALI3X* driver. I found a workaround is to disable this by putting the IDE devices into ATA66 mode.
Issuing 'knoppix ide0=ata66 ide1=ata66' at start will allow Knoppix to work properly on a Fujitsu Lifebook and presumably other platforms that use the Crusoe processor.
Kudos go to martin dempsey for the answer:
http://thcnet.net/pipermail/lvlug/20...er/008230.html
Cisco Meraki MS120-48LP 48 Port Blade Ethernet Switch UNCLAIMED
$799.00
NEW Cisco Meraki MR44 802.11ax Wi-fi 6 Wireless Access Point MR44-HW UNCLAIMED
$399.98
Cisco IP Phone 6841 – CP-6841-3PW-NA-K9=
$75.00
Cisco RV160 VPN Router 4 Gigabit Ethernet Ports RV160-K9-AR
$80.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco QSFP-40G-SR-BD BiDi Short-reach Transceiver, 1 Year Warranty
$17.25
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$44.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco WS-C3850-48F-S Catalyst 3850 48x 1GB PoE+ RJ-45 1x Module Switch
$185.00
Cisco C9300-48 48 Port Switch Dual PSU W/C9300-NM-8X P/N: C9300-48U-A Tested
$799.99