Boot like this:
boot: knoppix nofirewire
plus any other codes you may need.
Hi,
I use Knoppix on my Laptop and I am very pleased with it. But recently a co-worker wanted to run it on a similar Laptop and it hangs in the hardware detection. Is there a way to tell where it hangs? Booting in (almost) no hardware detection also hangs, as well as the expert mode. We also tried to run the Red Hat 9 Install on his PC, buut it also hangs at loading the ohci1394 driver. Is there a way to tell that Knoppix has the same problem? If the ohci1394 really is the problem, is there a way to prevent its loading?
Thanks,
Lothar
Boot like this:
boot: knoppix nofirewire
plus any other codes you may need.
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$249.99
Cisco 10-2456-03 Genuine Cisco SFP-10G-LRM V03 10GBASE-LRM SFP+Transceiver
$21.24
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00