Check out the Cheat Codes for optional bootup switches.
http://knoppix.net/wiki/Cheat_Codes
I have a 64-bit processor on a Dell 9360 machine.
If I boot into Knoppix 8.2.0 Live from a portable drive and run simple queries as follows I get:
$ lscpu
Architecture: x86_64
CPU op-mode(s): 32 bit,64 bit
Flags: ... lm ...
$ lshw -C processor | grep width
width: 64 bits
$ grep flags /proc/cpuinfo | grep " lm "
Flags: ... lm ...
which all confirm the 64-bit architecture. BUT the response
CPU op-mode(s): 32 bit,64 bit
apparently indicates that I am running a 64-bit-capable machine in 32-bit-mode.
Yes? - is this a true interpretation?
My /boot/isolinux/isolinux.cfg file contains the lines (omitting redundant qualifiers for ease of reading)
DEFAULT fergus
LABEL fergus
KERNEL ifcpu64.c32
APPEND knoppix64 -- knoppix
APPEND knoppix64
LABEL knoppix
KERNEL linux
APPEND initrd=minirt.gz
LABEL knoppix64
KERNEL linux64
APPEND initrd=minirt.gz
which I hoped meant "if 64-bit machine use 64-bit OS; if 32-bit machine use 32-bit OS" but apparently not.
How can I tweak the isolinux.cfg file to behave as required one line up?
Thank you!
PS1 I have to admit (I have only just noticed) that the file ifcpu64.c32 referred to above is very suggestive of an instruction "if 64-bit machine use 32-bit OS". Is that what it achieves, and the cause of the mismatch described?
PS2 I use this ifcpu file from the Knoppix 7.4.2 provision. I find the Knoppix 8.2.0 version stops Knoppix stone dead before it even starts. It simply does not work, at all. Anybody else?
Check out the Cheat Codes for optional bootup switches.
http://knoppix.net/wiki/Cheat_Codes
Cisco Meraki MS120-48LP 48 Port Blade Ethernet Switch UNCLAIMED
$799.00
NEW Cisco Meraki MR44 802.11ax Wi-fi 6 Wireless Access Point MR44-HW UNCLAIMED
$399.98
Cisco RV160 VPN Router 4 Gigabit Ethernet Ports RV160-K9-AR
$80.00
Cisco IP Phone 6841 – CP-6841-3PW-NA-K9=
$75.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco QSFP-40G-SR-BD BiDi Short-reach Transceiver, 1 Year Warranty
$17.25
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$44.99
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Cisco WS-C3850-48F-S Catalyst 3850 48x 1GB PoE+ RJ-45 1x Module Switch
$185.00
Cisco C9300-48 48 Port Switch Dual PSU W/C9300-NM-8X P/N: C9300-48U-A Tested
$799.99