The iso file is a CD IMAGE
so.. you don't burn the file ONTO the cd, but burn the file AS the cd.
In nero it's "burn image" or similar.
I am not experienced in CD burning, but I used Nero and I burned only the file knoppix_v3.1-2003-01-01-EN.iso
But when I try to boot with the CD, it doesn't boot.
Should I have to copy another file in the same CD to do the boot?
thks. Carlos
The iso file is a CD IMAGE
so.. you don't burn the file ONTO the cd, but burn the file AS the cd.
In nero it's "burn image" or similar.
Right click on the iso file and select from the menu :-Originally Posted by caalex
1) "Open with" -> "Choose Program" ie nero or
2) "Properties" -> "Opens with" use the [Change...] tab and select nero
Using good quality 700 meg media helps
rob
to burn from within nero, go to file, then burn image. select the iso, and u are all set. good luck
Also, make sure that the md5 checksums match after you DL.
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99