/boot/grub/menu.lst on your RH 8 root(assuming that is where you got the GRUB). I am not familar with RH so it may use a different file name for the menu entry.
I managed to install Knoppix 3.2 on my harddrive partitions hda6 (Linux ext3) and hda7 (Linux swap). I already have a Red Hat 8 on the hda1, hda2 and hda3 partitions, including the Grub boot manager.
How can I configure Grub to see the bootable Knoppix partition hda6? Is it just a matter of putting the correct entries into the 'grub.conf' file? If so, which ones? When I boot from CD, I normally use the following entries:
knoppix lang=us noapic 2
/boot/grub/menu.lst on your RH 8 root(assuming that is where you got the GRUB). I am not familar with RH so it may use a different file name for the menu entry.
Juniper SRX1500-SYS-JB-AC SRX1500 Services Gateway-Dual Power JPSU-400W-AC
$1784.00
Juniper MX204 +JUNOS and Dual Power Supply + Rack Mount-LIFETIME WARRANTY
$8395.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.12
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper EX4600-40F-AFI 24 SFP+/SFP Ports 4 QSFP+ Ports Dual AC Switch
$999.00
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper EX2300-48P PoE+ Switch 48x 1GbE & 4 SFP+/SFP 10G uplinks, Tested
$289.00
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00