I have just downloaded 3.3-2003-09-24. First time with Knoppix, so booted from CD and watched. It failed to start X. I Found a thread in Hardware Forum about giving options for Matrox G400 card so tried again - still failed and dropped me into a root console. Tried startx which failed with "Parse error on line 107" (of XF86Config-4). The line said "VertRefresh 49.0 - 8". Changing the 8 to 80 I tried again with success (using it now).
But is this a bug or is it me? I suspect this was causing failure of Knoppix to set up X even without passing extra parameters for video card - but then it tried several setups after that and left me with a completely unsuitable config.
I was not quite sure where to post this so hope you forgive me if this is the wrong place.
Cisco UCS 5108 Blade Server Chassis Enclosure 8x B200 M4 16x E5-2640v3 128gb
$599.99
HP ProLiant BL460c G8(Gen8) 2x 8 CORE E5-2670 2.6GHz 192GB RAM 2x 146GB SAS HDD
$78.00
DELL M630 BLADE SERVER x2 XEON E5-2660V3 @ 2.6GH H730 PERC HDD CADDIES 16GB FC
$50.00
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$349.00
DELL POWEREDGE M620 Blade 2x Xeon E5-2670 2.5GHz 128GB 2x300GB HDD
$94.50
Dell PowerEdge M1000e (BMX01) Server Enclosure w/ 16-PowerEdge M610 Blade Server
$899.99
Dell PowerEdge M620 Blade Server
$39.99
Dell PowerEdge M600 Blade Server 2 x Quad Core E5405 2.0 Ghz 32GB RAM No HDD
$29.95
UCSB-B200-M4 UCS Blade Server, 2x E5-2667 V3, 256GB RAM DDR4, 2x 300GB Drives
$299.99
Dell PowerEdge M630 Blade Server 2*Xeon E5-2630Lv3 8-Core 1.80GHz CPU 256GB RAM
$350.00