I have just downloaded 3.3-2003-09-24. First time with Knoppix, so booted from CD and watched. It failed to start X. I Found a thread in Hardware Forum about giving options for Matrox G400 card so tried again - still failed and dropped me into a root console. Tried startx which failed with "Parse error on line 107" (of XF86Config-4). The line said "VertRefresh 49.0 - 8". Changing the 8 to 80 I tried again with success (using it now).
But is this a bug or is it me? I suspect this was causing failure of Knoppix to set up X even without passing extra parameters for video card - but then it tried several setups after that and left me with a completely unsuitable config.
I was not quite sure where to post this so hope you forgive me if this is the wrong place.
Cisco QSFP-100G-LR4-S 100GBASE-LR4 QSFP28, 1310nm, 10km, LC, SMF
$335.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Cisco SFP-10G-BX40D-I 10GBASE-BX-D BiDi SFP+, 1330nm-TX/1270nm-RX, 40km, LC, SMF
$59.99
Cisco SFP-10G-T-X 10GBASE-T SFP+, 80m@Cat6a/Cat7, Copper, RJ45
$83.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Cisco GLC-SX-MMD SFP 1000Base-SX Short Haul Module 10-2626-01 - 1 Year Warranty
$21.49
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Cisco 10G SFP+ Module SFP-10G-SR 10-2415-03 (Lot of 5)
$24.99