Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Fanxiang 4TB 2TB 1TB SSD 550MB/s 2.5'' SATA III Internal Solid State Drive lot
$219.99
Fanxiang M.2 SATA SSD 2TB 1TB 512GB 256GB SSD Internal M2 Solid State Drive Lot
$109.99
Fanxiang SSD 4TB 2TB 1TB PS5 SSD M.2 NVME SSD 7300MBS PCIe 4.0 Solid State Drive
$269.99
Fanxiang 4TB 2TB 1TB SSD 2.5'' SATA III 560MB/s Internal Solid State Drive lot
$188.09
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$19.99
1080PRO 4TB SSD Solid State Hard Drive Ngff M.2 SSD Gaming Internal Hard Disk
$32.99
4tb Ssd 870 Evo Internal Solid State Drive Hard Disk Ssd 2.5 Inch Sata Iii 2tb D
$39.99
Samsung 860 EVO 250GB,Internal,2.5 inch (MZ-76E250) Solid State Drive
$20.00
Netac 1TB 2TB 512GB Internal SSD 2.5'' SATA III 6Gb/s Solid State Drive lot
$119.99
M.2 NVMe SSD 128GB 256GB 512GB Single Notch with Windows Installed 10 / 11
$85.25