Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
JUNIPER ELECTRONICS NFX250-ATT-LS1
$250.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$29.91
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
Juniper EX2200-48P-4G 48 LAN + 4 SFP Rack-Mountable POE Gigabit Ethernet Switch
$57.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper Networks SRX345 Gateway Appliance
$195.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch with RACK EARS, RESET
$46.99
Juniper 48-Port PoE GbE Network Switch w/ 4-Port 10GB SFP+ Module EX4300-48P
$179.99
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
Juniper EX2200-C-12T-2G Fanless 12-port Ethernet Switch with 2 SFP
$75.77