Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig Copper UPOE Network Switch
$499.00
Cisco WS-C2960X-48FPD-L 48 V07 POE+ GE+2 10G SFP+, LAN BASE 740W w/ C2960X-Stack
$140.00
Cisco 3560CG Series 8 Port POE Network Switch WS-C3560CG-8PC-S
$80.00
Cisco Nexus N9K-C93108TC-EX 48-Port 10G RJ-45 6x100G QSFP Network Switch W/Ears
$449.99
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$30.99
Original CISCO SFP-10G-SR V03 10-2415-03 850nm 10GBASE-SR SFP+ Multi mode Module
$6.80
Precision PRE-SFP-TMI-CSCO 1GB BASE-T RJ-45 SFP Transceiver - For Cisco
$2.89
CISCO SFP-10G-LR SFP TRANSCEIVER MODULE GBIC 10G 10GB SFP - 1 Year Warranty
$39.99
NEW Cisco C9300-NM-2Y Dual-Port SFP 25G Network Module / NEW -
$544.99
Cisco WS-C3560CX-12PC-S 12 Port GbE PoE IP Base Catalyst Managed Switch, TESTED
$174.00