Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$399.00
Dell PowerEdge FC430 Blade with 2 x Xeon 2680v3 CPUs
$120.00
CISCO UCSB-B200-M5 UCS B200 M5 BLADE SERVER - CAN BUILD TO SPEC
$495.00
HP ProLiant BL460c Gen9 Blade 2x E5-2690v4 2.6GHz =28 Cores 32GB P246 650FLB
$223.00
Dell PowerEdge M620 Blade Server 2 x Xeon e5 2665 8 x 16 GB(128) RAM - No HD
$59.99
HP ProLiant BL460c Gen9 Blade Server Intel Xeon E5-2698 v3 - 512GB RAM
$255.42
Sun Microsystems Blade 100 Workstation UltraSPARC-IIe 500MHz 256MB Server No HDD
$95.00
Dell PowerEdge M620 Blade Server 2x 10C E5-2690v2 64GB Ram 2x 600GB 10k HDD
$125.00
DELL PowerEdge M630 Blade 2x E5-2680v4 2.4GHz =28 Cores 128GB H330 2x10Gb X520
$275.00
HP ProLiant BL460c Gen9 Blade 2x E5-2660v4 2.0GHz =28 Cores 128GB P246 650FLB
$267.00