Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
1TB/2TB USB 3.0 Flash Drive Thumb U Disk Memory Stick Pen PC Laptop Storage lot
$580.99
Seagate ST1000LM035 Mobile HDD 1TB 2.5" SATA III Laptop Hard Drive 0 Relocated
$15.97
Type C USB 3.0 Flash Drive Thumb Drive Memory Stick for PC Laptop 1TB 2TB lot
$73.29
Samsung 1TB 850 EVO 2.5" SATA Solid State Drive MZ7LE1T0 ** READ **
$48.99
CISCO A03-D1TBSATA 1TB 7.2K 6G 2.5INCH SATA HDD
$9.00
1TB HDD/SSD 2.5" SATA Hard Drive for Laptop with Win 10/Win 11 Pro Pre-installed
$19.99
WD - Blue SN580 1TB Internal SSD PCIe Gen 4 x4 NVMe
$79.99
Samsung - Geek Squad Certified Refurbished 870 EVO 1TB SATA Solid State Drive
$67.99
Samsung - 990 980 970 PRO & EVO 4TB 2TB 1 TB Internal PCle Gen 4x4 NVMe M.2SSD
$320.00
Internal HDD SATA 3.5" 250GB-2TB Hard Drive with Legacy Windows 11 Pro Installed
$27.69