Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$22.45
SK Hynix 8GB (1x8GB) PC4-19200 DDR4-2400T Laptop Memory SDRAM HMA81GS6AFR8N-UH
$10.99
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
Micron 8GB DDR4 1Rx16 PC4-3200AA Laptop RAM Memory MTA4ATF1G64HZ-3G2E2
$10.00
Crucial 8GB SO-DIMM PC3-12800 (DDR3-1600) Memory
$9.49
CORSAIR - VENGEANCE LPX 32GB (2x16GB) 3200MHz DDR4 C16 DIMM Desktop Memory
$59.99
Corsair VENGEANCE LPX 16GB (2x8GB) DDDR4 DRAM 3200MHz Memory Module Kit - Black
$24.99
LOT 8x 16GB (128GB) Samsung M393B2G70DB0-CMA PC3-14900R DIMM Server Memory
$35.99
Set Of 10 Samsung (1 x 8GB) PC4-21300 So DIMM So(DDR4-2666) Memory - SET OF 10
$100.00