Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Dell SNPTP9W1C/16G 16 GB 2666MHz (PC4-2666) Memory Ram
$34.95
Crucial 8GB 1x8GB PC RAM PC3L 12800U DDR3 1600MHz Desktop Memory DIMM
$8.36
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Team Group Elite+ 16GB (8GBx2) DDR4 2400MHz RAM (TPRD48G2400HC16BK)
$23.99
Team T-FORCE VULCAN Z 32GB (2 x 16GB) PC RAM DDR4 3200 (PC4 25600) Memory
$54.99
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$22.45
NEW OLOy 16GB 2x8GB KIT DDR4-3000 PC4-24000 Desktop Gaming RAM MD4U0830160BB1ST
$19.99
Micron 16GB DDR4-2400 SODIMM MTA16ATF2G64HZ-2G3E1 Laptop Memory RAM
$21.99
128GB Kit 4x 32GB PC4-17000 LRDIMM DELL POWEREDGE R730xd R730 R630 Memory RAM
$127.96
HYNIX HMT31GR7BFR4C-H9 8GB PC3-10600R DDR3-1333MHZ 2Rx4 (LOT OF 8) DRAT-3
$999.00