Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
CRUCIAL DDR3L 8GB 16GB 32GB 1600 MHz PC3-12800 Laptop Memory RAM SODIMM 204-Pin
$14.35
Team T-FORCE VULCAN Z 16GB (2 x 8GB) 288-Pin PC RAM DDR4 3200 (PC4 25600) Intel
$35.99
A-Tech 16GB 2 x 8GB PC3-12800 Laptop SODIMM DDR3 1600 Memory RAM PC3L 16G DDR3L
$27.98
HMT84GL7AMR4C-RD 32GB DDR3 Server Memory RAM 14900L ECC REG 4Rx4 SK Hynix Cisco
$13.99
A-Tech 16GB 2x 8GB PC3-12800 Desktop DDR3 1600 MHz 240pin DIMM Memory RAM 16G 8G
$27.98
Hynix 64GB 4Rx4 PC4-2133P-L LRDIMM DDR4-17000 ECC Load Reduced Server Memory RAM
$64.99
A-Tech 32GB 2x 16GB PC4-25600 Laptop SODIMM DDR4 3200 MHz Non-ECC Memory RAM 32G
$59.99