Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Micron 8GB DDR4 1Rx16 PC4-3200AA Laptop RAM Memory MTA4ATF1G64HZ-3G2E2
$10.00
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$22.45
Micron 16GB DDR4-2400 SODIMM MTA16ATF2G64HZ-2G3E1 Laptop Memory RAM
$21.99
Samsung 8GB (2x4GB) DDR3 1600MHz PC3 Desktop RAM Memory | M378B5173DB0-CK0 |
$8.30
Team T-FORCE VULCAN Z 32GB (2 x 16GB) PC RAM DDR4 3200 (PC4 25600) Memory
$54.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$16.50
Patriot Memory PDV225G6400LLK DDR2 800MHz 2GB (2 x 1GB) Set of 2 4GB Total
$29.98
A-Tech 128GB 4x 32GB 2Rx4 PC4-19200R DDR4 2400 ECC REG RDIMM Server Memory RAM
$191.96
USB Flash Drive Memory Stick Pendrive Thumb Drive 4GB, 8GB, 32GB, 64GB 128GB LOT
$230.40