Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP, 1310nm, 2km, LC, MMF
$83.99
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco w/ Green Hologram DS-SFP-FC32G-SW FC 32G FC SFP+ Transceiver Module
$85.00
Cisco Systems Nexus 7700 10 Slot Chassis Fab 3 Mod | N77-C7710-FAB-3
$4999.99
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco Nexus N9K-C93180YC-EX 48-Port 1/10/25G SFP + 6 40G/100G QSFP28 Switch
$789.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco Catalyst 3850 WS-C3850-48U-S 48-Port UPOE Gb Switch w/ NM-2-10G (BH)
$134.96
Cisco N5K-C5010P-BF 20-Port Nexus 5010 Series 10GbE Gigabit Ethernet Switch
$119.99