Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
128GB Kit 4x 32GB PC4-17000 LRDIMM DELL POWEREDGE R730xd R730 R630 Memory RAM
$127.96
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Micron 8GB DDR4 1Rx16 PC4-3200AA Laptop RAM Memory MTA4ATF1G64HZ-3G2E2
$10.00
TEAMGROUP T-FORCE DELTA RGB 32GB (2 x 16GB) (DDR5-5600) DIMM CL30 ff3d516g5600h
$69.99
Micron 16GB (2x8GB) PC4-2400T DDR4 SODIMM RAM
$18.99
Micron 16GB DDR4-2400 SODIMM MTA16ATF2G64HZ-2G3E1 Laptop Memory RAM
$21.99
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$22.45
Team Group Elite+ 16GB (8GBx2) DDR4 2400MHz RAM (TPRD48G2400HC16BK)
$23.99
HYNIX HMT31GR7BFR4C-H9 8GB PC3-10600R DDR3-1333MHZ 2Rx4 (LOT OF 8) DRAT-3
$999.00
APPLE MACBOOK AIR 13 INCH LAPTOP | 8GB RAM | 256GB SSD | WARRANTY | 2017-2020
$349.00