Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Cisco FPR-NM-8X10G FirePower 8 port 10GBE SFP+ Network Module
$619.99
Cisco Nexus N9K-C93108TC-EX 48P 10GbE 6P 100GbE QSFP28 Switch N9K-C93108TC-EX
$499.00
Cisco WS-C3850-12X48U-L 48 Port 10/100/1000 Modular Uplink Switch-Same Day Shipp
$198.95
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch + NM-8X Module
$549.97
Cisco SFP-10G-SR 10-2415-03 10 Gigabit Transceiver LOT OF 10 @ C
$39.99
Cisco Nexus N9K-C9372TX 48P 10G Gigabit Ethernet 6x QSFP+ 40G Switch 2x650W PSU
$189.99
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
New Sealed Cisco GLC-SX-MMD 1000BASE-SX Transceiver Module *US Shipping*
$11.00
Cisco Nexus N9K-C92160YC-X 48P 25GbE SFP28 6P QSFP+/QSFP28 PE Switch
$475.00
Lot of 30 Genuine CISCO GLC-TE 30-1475-03 GBIC 1000BASE-T RJ-45 SFP+ Transceiver
$399.99