1. I have live knoppix 7.7.1 (with persistence) on a 14.3 GB usb stick, which I
plug into a laptop.
2. My humble questions are:
a) How do I set it up so that I can use hibernate?
b) What command do I run to perform the hibernation?
c) To wake up from hibernation, do I just insert the usb stick then turn the
power on?
3. I've tried running
$ sudo pm-hibernate
but it doesn't hibernate, and after a few seconds it just returns to the
command prompt.
However I am able to use suspend successfully with
$ sudo pm-suspend
4. The following are the partitions on the usb stick:
Partition 1 is 4.4 GB, and its label is "KNOPPIX".
Partition 2 is 4.9 GB, and its label is "KNOPPIX-DATA" (persistence).
Partition 3 is 5.0 GB, and is a Swap partition created by me.
Altair 8800 CPU Board Working *TESTED* reproduction
$790.00
MITS ALTAIR 8800 Vintage Computer w/ Keyboard, Floppy, boards - Buy It Now
$9875.00
S100 Backplane Edge Connector (IMSAI, Altair, etc.)
$15.00
MITS ALTAIR 8800 B Original Vintage Microcomputer
$5250.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$8900.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
New Unused S-100 Bus Edge Card Connector / Old Vintage Altair Imsai Computer
$9.99
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$358.99
Wenger laptop backpack, Altair, 15.6 inch, tablet compartment, Black
$164.99