1. I have live knoppix 7.7.1 (with persistence) on a 14.3 GB usb stick, which I
plug into a laptop.
2. My humble questions are:
a) How do I set it up so that I can use hibernate?
b) What command do I run to perform the hibernation?
c) To wake up from hibernation, do I just insert the usb stick then turn the
power on?
3. I've tried running
$ sudo pm-hibernate
but it doesn't hibernate, and after a few seconds it just returns to the
command prompt.
However I am able to use suspend successfully with
$ sudo pm-suspend
4. The following are the partitions on the usb stick:
Partition 1 is 4.4 GB, and its label is "KNOPPIX".
Partition 2 is 4.9 GB, and its label is "KNOPPIX-DATA" (persistence).
Partition 3 is 5.0 GB, and is a Swap partition created by me.
Juniper MX104-AC 4 MIC Slot Chassis w/ 2x RE-S-MX104 and 2x PWR-MX104-AC
$1899.00
*New* MIC-MRATE Juniper 12-Port Multi-Rate MIC module
$749.00
Juniper 48-Port PoE GbE Network Switch w/ Dual Power Supplies F B EX4300-48P
$178.99
Juniper Networks EX2300-24P 24 Port Gigabit PoE 4 SFP 1/10G Network Switch
$119.00
Juniper EX4600-40F-AFO 24x SFP+/SFP & 4x QSFP+ Ports Switch 2XPSU TESTED
$800.95
Juniper EX4300-48T 48 Port 1G 4 QSFP 40G Dual PSU AFO w/ Rails, EX-UM-4X4SFP Mod
$169.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper EX3400-48P 48-Port PoE+ 4x SFP+ 2x 40G QSFP+ Dual PSU & Fan AFO Switch
$269.99
Juniper QFX5100-48S 48-Port 10GbE SFP+ 6x40GbE QSFP Network Switch w/Ears Tested
$599.99
Juniper Networks SRX550 Services Gateway Security Appliance with 6x XGPIM 2x PSU
$499.00