1. I have live knoppix 7.7.1 (with persistence) on a 14.3 GB usb stick, which I
plug into a laptop.
2. My humble questions are:
a) How do I set it up so that I can use hibernate?
b) What command do I run to perform the hibernation?
c) To wake up from hibernation, do I just insert the usb stick then turn the
power on?
3. I've tried running
$ sudo pm-hibernate
but it doesn't hibernate, and after a few seconds it just returns to the
command prompt.
However I am able to use suspend successfully with
$ sudo pm-suspend
4. The following are the partitions on the usb stick:
Partition 1 is 4.4 GB, and its label is "KNOPPIX".
Partition 2 is 4.9 GB, and its label is "KNOPPIX-DATA" (persistence).
Partition 3 is 5.0 GB, and is a Swap partition created by me.
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco RV320 Dual WAN VPN 4 Port Gigabit Router w/ Web Filtering RV320-WB-K9-NA
$374.00
Cisco 1100 Terminal - gateway - rack-mountable C1100TGX-1N24P32A
$1349.00
Cisco RV340W 1000Mbps Dual WAN Gigabit VPN Wireless AC Router RV340W-A-K9-NA
$183.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
CISCO ASR-920-24SZ-M ASR920 w/ ASR920-24G-4-10G lic 2x DC PSU
$399.99
Cisco C9300-48 48 Port Switch Dual PSU W/C9300-NM-8X P/N: C9300-48U-A Tested
$799.99
New Cisco C9200-NM-4X Catalyst 9200 Series Network Module 4 X 10GE *MINT*
$429.97