1. I have live knoppix 7.7.1 (with persistence) on a 14.3 GB usb stick, which I
plug into a laptop.
2. My humble questions are:
a) How do I set it up so that I can use hibernate?
b) What command do I run to perform the hibernation?
c) To wake up from hibernation, do I just insert the usb stick then turn the
power on?
3. I've tried running
$ sudo pm-hibernate
but it doesn't hibernate, and after a few seconds it just returns to the
command prompt.
However I am able to use suspend successfully with
$ sudo pm-suspend
4. The following are the partitions on the usb stick:
Partition 1 is 4.4 GB, and its label is "KNOPPIX".
Partition 2 is 4.9 GB, and its label is "KNOPPIX-DATA" (persistence).
Partition 3 is 5.0 GB, and is a Swap partition created by me.
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MITS 8800 CPU Card 8080A S-100 S100 replica IMSAI CP/M
$35.00
$22.50
Build S-100 Bus Computer Peripherals Altair 8800 IMSAI 8080 Disk I/O Graphics
$59.99
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99