1. I have live knoppix 7.7.1 (with persistence) on a 14.3 GB usb stick, which I
plug into a laptop.
2. My humble questions are:
a) How do I set it up so that I can use hibernate?
b) What command do I run to perform the hibernation?
c) To wake up from hibernation, do I just insert the usb stick then turn the
power on?
3. I've tried running
$ sudo pm-hibernate
but it doesn't hibernate, and after a few seconds it just returns to the
command prompt.
However I am able to use suspend successfully with
$ sudo pm-suspend
4. The following are the partitions on the usb stick:
Partition 1 is 4.4 GB, and its label is "KNOPPIX".
Partition 2 is 4.9 GB, and its label is "KNOPPIX-DATA" (persistence).
Partition 3 is 5.0 GB, and is a Swap partition created by me.
XGS-PON ONU SFP+ Stick MAC SC/APC 1270/1577nm -40 to 85°C 10G/10G XGSPON ONT
$199.99
Unify Transceiver Module - UACC-CM-RJ45-10G
$39.00
Lot of 10 Cisco SFP-10G-SR 10-2415-03 V03 10GBase-SR 850nmSFP+Transceiver Module
$34.95
Cisco SFP-10G-SR SFP Transceiver Module
$13.00
🔥🔥🔥Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver 10-2415-03 🔥🔥🔥
$8.00
INTEL 10G SFP+ SR SFP E10GSFPSR FTLX8571D3BCV-IT For X520-DA2 X520-SR2 X710-DA2
$9.49
Cisco SFP-10G-SR 10-2415-03 10 Gigabit Transceiver LOT OF 8
$24.00
(Lot of 10) Cisco SFP-10G-SR SFP+ Transceiver Module 10-2415-03
$25.00
For Cisco SFP-10G-T, Ubiquiti UF-RJ45-10G Transceiver, SFP+ to RJ45 10GBase-T
$40.99
Dell X1018 X-Series Smart Managed Switches 16-Port Gigabit 2-Port SFP Switch
$45.00