Did you try as su or root):
This worked for me.Code:mount /dev/hda1 /mnt/hda1 -oremount,rw
Hello,
I have installed Knoppix on my HD, and it's working fine![]()
Just a problem for the hda1winslow98 access wich is mounted in root mode.
I tried to chmod 755 it, but, no result, I can accessing to it only as su.
if someone know the solution...![]()
Did you try as su or root):
This worked for me.Code:mount /dev/hda1 /mnt/hda1 -oremount,rw
I tried the command, but it has not worked
I found that in /etc/fstab, the hda1 entry was preceded by a # and the mode was noauto
After deleting # and converting noauto by auto & rebooting, it's working fine![]()
but...the floppy have the same problem, and the /etc/fstab entry is
/dev/fd0 /floppy vfat defaults,user,noauto,showexec,umask=022 0 0 (with no #)
is it the same problem ? 2 advice are better than 1![]()
ThX
Normally you have to mount a floppy disk by hand, because each time you change the floppy it has to be unmounted before you remove it and mounted after youput the new one in.
Yes it works, and I'm happy that KNOPPIX does'nt use automount by default ; it's a source of problems with a lot of "big" linux distros.
Thank you![]()
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
Juniper Networks EX4400-48MP 48 port 5GbE + 12 port 10 Gigabit PoE++ Switch -NEW
$1400.00
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper Networks EX2200-C-12P-2G Gigabit Ethernet Managed Switch
$79.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$135.00
Juniper EX2200-C-12T-2G 12-Port 10/100/1000 2x SFP Uplinks Compact Switch
$74.99
Juniper Networks SRX320-POE 6-Port Service Gateway Security Appliance Tested
$149.99
Juniper Networks EX2300-48P 48 Port Gigabit PoE 4 SFP 1/10G Network Switch
$185.00
Juniper Networks MX80-AC Router 4 Port XFP 10G MIC-3D-200E-SFP
$600.00