I downloaded and burned the new Knoppix 3.3 LiveCD (11-03-03).
The md5 checksum was OK.
The CD boots ok, but after i get the penguin graphic in the upper left
of my screen, I get these errors about "hde: drive not ready for
command" and "hdf: drive not ready for command"
hde and hdf are my two physical hard disks, which are on a Promise TX133
controller card, neither drive is a boot drive.
I have Knoppix 3.2 also, and it boots just fine.
So what could be the issue with 3.3?
I have tried some of the cheatcode kernel options, like failsafe, but it
always stops booting after the above errors.
Cisco SG200-26 26-Port Gigabit Network Smart Switch
$76.49
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$249.99
NETGEAR ProSafe (GS752TP-100NAS) 48 Port Rack Mountable Ethernet Switch OpenBox
$1450.00
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95