I booted it back up the next day and now it works fine. Don't know what the problem was. I'll see what happens next time.![]()
I have a Prism 2.5 chip in an IBM Thinkpad T23. Knoppix seems to recognize this mini-PCI card and loads the appropriate driver and gives me a eth0 device. I run wlcardconfig (or iwconfig), enter the correct settings and everthing appears to be ok. I then run 'wavemon' and I seem to have a good connection to my AP. The problem is that it's not grabbing an ip from my router. When I run 'pump -i eth0' it comes back with 'operation failed'. Everything that I have read says to use pump to initiate dhcp. What am I missing here? BTW, my 10/100 lan card on the same laptop (configured as eth1) grabs an ip right away.
Also, I still can't seem to get WEP to work. I've read all the posts on this website about WEP setup and I've tried it all but the only thing that seems to work is disabling WEP on my AP. Is there anything special for this Prism 2.5 chip?
If you have any suggestions please respond. Thanks!
I booted it back up the next day and now it works fine. Don't know what the problem was. I'll see what happens next time.![]()
Dell EMC 092GD6 Broadcom 9305-16i LSI Quad Port 4 Port SAS RAID Controller
$84.99
ORICO 5 Bay Raid Enclosure USB3.0 SATA External Hard Drive Enclosure Up to 80TB
$118.99
ORICO 5 Bay Raid USB3.0 to SATA External Hard Drive Enclosure for 3.5'' HDD LOT
$140.79
OWC Guardian Maximus Raid Enclosure SATA Hard Drive FireWire
$36.99
ASUS Hyper M.2 x16 Gen 4 RAID Card- Used Working
$32.95
Dell PERC H330 PCIe 3.0 x8 RAID Storage Controller 4Y5H1 High Profile
$17.99
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$54.66
WD TB My Book Duo Desktop RAID External Hard Drive 0TB NO DRIVES
$42.00
CompUSA Internal 2 Bay Removable Rack for 3 SATA Hard Drives Raid Configurations
$25.00
Yottamaster 5 Bay RAID Hard Drive Enclosure Type-C B For 2.5" 3.5" SATA HDD SSDs
$131.59