Erik,
I have a SMC card to. It seems it's not supported. So I replaced it for a 3C509.
I could find that card-driver
I have an SMC EtherEZ ISA card, which works fine under gentoo and Mandrake, but for some reason simply does not want to load under the latest knoppix (haven't tried earlier versions).
Under gentoo (on the same box) the card is using io=0x300 irq=10, under Knoppix, it isn't detected and when I try to modprobe it directly with the same parameters (and just about all other valid ones) it doesn't load and gives the "No such device or address" message.
basically, i'm just doing "modprobe smc-ultra io=0x300 irq=10" from the root command shell.
Anyone have any ideas?
Erik,
I have a SMC card to. It seems it's not supported. So I replaced it for a 3C509.
I could find that card-driver
LOT OF 10 HPE JD092B X130 10G SFP+ LC SR Transceiver
$40.00
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Ubiquiti Networks UniFi USW-24 Gigabit Managed Switch/SFP, 24-Port
$190.00
New Cisco GLC-TE 1G SFP Copper RJ45 100m 1000BASE-T Transceiver Module
$19.99
NEW FS SFP-10G-T 10GBASE T SFP+ 30M Transceiver Module (Lot of 1 Unit)
$39.95
HP 10Gb SR SFP+ 10GBASE-SR 455885-001 10Gigabit Ethernet Transceiver 456096-001
$6.99
🔥🔥🔥SFP-10G-SR V03 Original CISCO 10-2415-03 850nm 10GB SFP+ Multi Module🔥🔥
$6.80
Precision PRE-SFP-TMI-CSCO 1GB BASE-T RJ-45 SFP Transceiver - For Cisco
$2.89
New Sealed Cisco SFP-10G-LR 10GBASE-LR SFP Plug-in Transceiver Module
$15.00
For Cisco SFP-10G-T, Ubiquiti UF-RJ45-10G Transceiver, SFP+ to RJ45 10GBase-T
$49.99