-
dsl connection
Hi
I've installed to the hd and am trying to get connected to the dsl.
On the debian-knoppix forum Klaus Knopper said to addthe line
auto eth0
iface eth0 inet dynamic dhcp
to /etc/network/interfaces
I believe that I have done this (it shows up when I "less" the file.
But no connection.
When I went the second time to edit the file (It did not seem to stick the first time!) The following message appeared
E325 ATTENTION
found a swap file by the name...
As far as i Know I did not enter anything about a swap file
Thanks to all
-
Member
registered user
dsl connection
Hi,
I configed the dsl connection with the same progs I used in the cd booted system (exept there is normally no KNOPPIX menu entry).
Ran as root /usr/sbin/netcardconfig
Configured the nic to a static adress:
IP: 192.168.98.1
Netmask: 255.255.255.0
Broadcast: 192.168.98.255
Gateway: empty
DNS: empty
Afterwards I ran (as root again) /usr/sbin/pppoeconf
configed dsl provider &c.
Connects @ boottime.
I did this w/ about 25 installations - absolutely no probs.
tom
-
dsl conection
tuxtom
Many thanks for your reply
I looked at /usr/sbin/netcardconfig using "less":
1) there is a _lot_ of stuff
2) I believe that there are hundreds, if not thousands, of files like this in the OS
3) i am _completely_unable to understand how any _one_ man, i.e Klaus Knopper, could create a functioning OS. Even if you compare the work to writing a thousand page book, in which a few punctuation mistakes would be insignificant, in the OS a misplaced comma could prevent any function.
As you can see I have no experience in looking at , or "editing", a computer file.
There were some "MESSAGES" in the file, but no blank lines near them to enter any more info.
At some point I found that the gui was frozen; I went to man shutdown as root and thought that if I entered, as root, shutdown -h-t10, this would shut the computer down. Nothing happened so after Ctrl-Alt-Dlt the computer rebooted into the gui login and I clicked on
halt.
I mention this only to give you some idea of ny utter "newbieness!"
Perhaps I must wait for a much more newbie friendly install
Thanks again
Similar Threads
-
By davec51 in forum MS Windows & New to Linux
Replies: 0
Last Post: 12-02-2004, 07:13 PM
-
By l0815 in forum Networking
Replies: 0
Last Post: 11-12-2004, 08:27 PM
-
By Tetsuo in forum Networking
Replies: 1
Last Post: 07-29-2004, 11:06 AM
-
By Delbor in forum Networking
Replies: 0
Last Post: 12-19-2003, 12:41 AM
-
By tagamichi in forum Networking
Replies: 2
Last Post: 11-21-2003, 07:31 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
lot of 10 Juniper EX-SFP-10GE-SR Compatible 10GBASE-SR SFP+ 850nm 300m DOM -J499
$209.00
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$205.00
Juniper EX3300-48P, 48 Port PoE+ Gigabit Network Switch w/ Power cord
$54.99
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.07
JUNIPER EX4550-32F-AFO 32-PORT ETHERNET SWITCH 2x POWER SUPPLY - TESTED
$299.99
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00