HP Omnibook 500
Knoppix 3.3
When I boot the laptop with the lid closed, I get an Invalid Mode error, and nothing else will display during bootup until KDE loads. Then everything is fine, but if the laptop goes to sleep, wakes up, shuts down, etc where it would go back to console mode, it just displayes the Invalid Mode error.
If I boot with the lid open, it doesn't happen.
Any thoughts?
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99