-
Invalid Mode Error when lid is closed
HP Omnibook 500
Knoppix 3.3
When I boot the laptop with the lid closed, I get an Invalid Mode error, and nothing else will display during bootup until KDE loads. Then everything is fine, but if the laptop goes to sleep, wakes up, shuts down, etc where it would go back to console mode, it just displayes the Invalid Mode error.
If I boot with the lid open, it doesn't happen.
Any thoughts?
Similar Threads
-
By xinfo in forum General Support
Replies: 5
Last Post: 10-17-2004, 05:31 PM
-
By bluecinnabar in forum General Support
Replies: 0
Last Post: 07-15-2004, 04:41 AM
-
By Mustang64 in forum General Support
Replies: 1
Last Post: 04-17-2004, 05:57 AM
-
By warawara in forum General Support
Replies: 2
Last Post: 04-15-2004, 03:56 PM
-
By Tacvek in forum General Support
Replies: 3
Last Post: 09-12-2003, 01:23 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco SFP-10G-T-S 10GBASE-T SFP+, 30m@Cat6a/Cat7, Copper, RJ45
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Cisco SFP-10G-BX40D-I 10GBASE-BX-D BiDi SFP+, 1330nm-TX/1270nm-RX, 40km, LC, SMF
$59.99
Cisco GLC-TE 1000BASE-T SFP, 100m, Copper, RJ45
$27.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95