netcardconfigOriginally Posted by LRutker
When on a dhcp network all works well.
How do I configure when I plug into a port that has a set IP address?
netcardconfigOriginally Posted by LRutker
Mind elaborating please?
Open a console window (clam shell icon on taskbar) and type in the above command hit enter key fill in the required information. If running from the hard drive then use su and enter key type in root password enter key again and go through the step above.Originally Posted by LRutker
As Stephen said, you can run it from a command window. You can also run it right from the Knoppix menu (it's under networking). I'm usually verbose in my posts, but this time didn't see much point; figured if you wanted detalis you would do a "man netcardconfig" and get them.Originally Posted by LRutker
You might want to read this thread for a solution that would let you use a static IP address and still boot up Knoppix from CD and use DHCP to configure it:
http://www.knoppix.net/forum/viewtopic.php?t=7020
Thanks
Juniper EX2300-C-12P, 12 Port FANLESS POE Ethernet Switch EX2300-C
$375.00
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
Juniper Networks EX2200-C Gigabit Ethernet Managed Switch | EX2200-C-12P-2G
$49.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper EX3400-48P 48 Port Switch PoE+ 4x SFP+ 2x QSFP 1xAC *Tested/Warranty*
$139.95
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper Networks SRX320-POE 6-Port Service Gateway Security Appliance Tested
$149.99
Juniper QFX5100-48T 48-Port 10G SFP 6-Port 40G QSFP Ethernet Switch Tested
$312.69
Juniper Networks EX4400-48MP 48 port 5GbE + 12 port 10 Gigabit PoE++ Switch -NEW
$1200.00
Juniper Networks EX2300-48P 48 Port Gigabit PoE 4 SFP 1/10G Network Switch
$185.00