What does ifconfig -a return?
Thank you,
Joshua SS Miler
The Kernel seems to recognize the gigabit ethernet card and displays:
Intel(R) PRO/1000 Network Driver - version 3.1.23
Copyright etc...
It actually displays this twice. However when I try to config the interface:
ifconfig eth0 192.168.1.100 netmask 255.255.255.0
I get:
SIOCSIFADDR: No such device
eth0: ERROR while getting interface flags: No such device
SIOCSIFNETMASK: No such device
when I cat /proc/pci I can see the details of the NIC.
Any suggestions?
Thanks in advance.
What does ifconfig -a return?
Thank you,
Joshua SS Miler
Apparantly there are at least a few versions of this card, the verison I have is an onboard version on the Intel motherboard that comes with the GX260 from Dell. Anyway, the current version of the driver available on Intel's website works fine for my card. Unfortunately, many distributions that have this driver use the kernel code that is about a full release version behind (3.x instead of 4.x) Thanks for your suggestion, if I have any reason to boot into Knoppix again anytime soon I will try it and post the results here. However I was only trying to use knoppix to get a partimage system that would work with a lot of different hosts. Thanks again.
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100LX 100BASE-LX SFP Transceiver Module
$15.59
Cisco GLC-FE-100LX-RGD 100BASE-LX SFP Transceiver Module
$17.99
Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 100m LC MMF
$68.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00