Did you try commenting out the lines under #enable DMA with hdparm in /etc/init.d/bootmisc.sh?
Hi,
I just installed Knoppix onto hard disk, to co-exist with Windows 98 on the other partition. Install went fine but the system hangs with the following text:
hda1 hda2 < hda5 hda6 >
ide late registration of driver
[many lines later]
hda: dma_timer_expiry dma status==0x20
hda: timeout waiting for dma
hda: __idle_dma_test_irq called while not waiting
hda: status error 0x58 {DriveReady SeekComplete DataRequest}
hda: drive not ready for command
At this point, the drive LED is lit continuously and I have to hit the reset button.
On rebooting, the system runs fsck, fails to complete, tells me
I need to manually fix the disk and keaves me at the root prompt.
At this point, if I remount /dev/hda all seems to be fine. Using
hdparm I can run disk tests etc, and I can run every program
I need to.
If I shut the system down and restart, I get back to the same
hang problem again.
BTW - hdparm tells me that DMA on the HDD is off. I don't see
any difference setting it on, nor does BIOS appear to affect things.
Any suggestions greatly received.
--mco
Did you try commenting out the lines under #enable DMA with hdparm in /etc/init.d/bootmisc.sh?
I suspect either a cabling/jumpering error (don't set the drives using cable select, set them to "slave" and "master": use the end connectors for the master or motherboard, the middle one for slave) or that the bios (take a look under automatic recognition if hard drives -- often the first "item" on the bios lists) isn't set to the device being DMA.
Windows (especially 9*) is very tolerant of cabling/jumpering errors, Linux uses hardware harder, so can't be.
Thanks
Commenting out the enabling of DMA in bootmisc.sh did the trick.
Up and running. Yay!
--mco
Cisco SF350-08 8-Port Managed 10/100 Switch SF350-08-K9-NA
$164.00
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP, 1310nm, 2km, LC, MMF
$83.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
SFP-10G-SR V03 Original CISCO 10-2415-03 850nm 10GBASE-SR SFP+ Multi mode Module
$6.80