-
Card not seen
Greetings knoppix gurus,
I was able to get the drivers for my Orinoco gold card from Proxim's website. This has been a grat boon to my installed linux box. Is there a way to get knoppix cd to "see" my card? How do I go about installing drivers when my system is running off a c.d.?
Thanks in advance.
-
Senior Member
registered user
Best way is to remaster the CD and insert the drivers into the filesystem before turning it back into an .iso.
I believe you can save the driver module (file ending in ".o" on a boot floppy and specify that knooppix should load drivers from your drvier disk by using the driverdisk cheatcode.
Similar Threads
-
By supermal in forum Networking
Replies: 0
Last Post: 04-28-2005, 02:23 PM
-
By hazenmeek in forum Networking
Replies: 1
Last Post: 04-23-2003, 05:50 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
MITS Altair 680 Case Only LS3
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00