Better move this post the 'HD install' section.
Following a standard Knoppix 3.3 hard disk install the wheel on my Logitech Cordless MouseMan scrolls perfectly, but when I click it, it produces the same behaviour as the button that is under my thumb. I would like the "thumb button" to be recognised as a different button. I have checked on the web and tried the various different setups, but nothing changes.
The relevant section of my XF86config file is:
And after restarting X, I type into a console window:Section "InputDevice"
***Identifier "Logitech Cordless Mouseman Wheel"
***Driver "mouse"
***Option "Device" "/dev/mouse"
***Option "Protocol" "MouseManPlusPS/2"
***Option "Emulate3Buttons" "no"
***Option "Buttons" "6"
***Option "ZAxisMapping" "5 6"
EndSection
Which produces the following error:xmodmap -e "pointer = 1 2 6 3 5 4"
Any suggestions?xmodmap: commandline:0: bad number of buttons, must have 5 instead of 6
xmodmap: 1 error encountered, aborting.
Thanks,
Tim
Better move this post the 'HD install' section.
Sorry, I will repost this question in hdinstall.
Thanks,
Tim
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
Samsung 128GB (4x 32GB) M86B4G70DM0-CMA3 PC3-14900L 4Rx4 DDR3 ECC Reg Server Mem
$39.99
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
Lot of 2 32GB DDR4 2666 PC4-21300 SODIMM RAM Modules Mixed Brand
$60.00
Samsung 16GB 2Rx4 PC4-2400 RDIMM DDR4-19200 ECC REG Registered Server Memory RAM
$20.99
8GB PC3L-12800S 1600MHz SODIMM DDR3 RAM | Grade A
$12.00
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96
A-Tech 128GB 2x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$143.98