Hello,
I am trying to use Knoppix and when I'm booting from the CD it gets to this point and says"processor 0 is M11 3 x core/bus clock 200 MHz" and it will go no further and my computer is frozen,I have to unplug it from the wall to get it to shut down and then I manually open the cd-rom to remove the Knoppix CD and turn the computer back on.This is a eTower 266 ,Cyrix m11 CPU,2.1 GB HD.Also I ran on my other computer and runs fine but when you logout and hit return key after cd ejects it sits there and I had to do the three finger salute aand the 98SE loaded half way and the monitor screen went bkack so I reset manually and it booted normally.Any help would be appreciated,wombat
Juniper EX2300-C-12P, 12 Port FANLESS POE Ethernet Switch EX2300-C
$375.00
Juniper EX4300-48T-AFI 48x 1GB RJ-45 4x 40GB QSFP+ Switch - Same Day Shipping
$189.95
Juniper Networks SRX340 SRX300 Series 8-Port Security Firewall Tested
$129.00
Juniper Networks EX2200-C Gigabit Ethernet Managed Switch | EX2200-C-12T-2G
$49.99
Juniper Networks SRX320-POE 6-Port Service Gateway Security Appliance Tested
$149.99
Juniper Networks SRX345 Gateway Appliance
$199.99
Juniper EX3400-48P PoE+ 48x Gb 4x SFP+ Network Ethernet Switch Single PSU
$124.99
Juniper EX3400-48P 48-Port PoE+ 4x SFP+ 2x 40G QSFP+ Dual PSU & Fan AFO Switch
$99.99
Juniper Networks EX4400-48MP 48 port 5GbE + 12 port 10 Gigabit PoE++ Switch -NEW
$1200.00
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00