I've switched my old 21" Sony monitor with a Samsung SyncMaster 173S flat panel. After the switch, the quality of the display is not as desirable, so I decided to change the monitor setting through the control center. I saved the changes and reboot the machine. My nightmare started.
Now once I boot the machine, I have the message "Video mode not supported" message. I tried booting from my knoppix CD and setting the display to the lowest resoluation and refresh rate, hopping that I can get back to a good start and trying reseting the Monitor, but nothing works.
I read in this forum that I can use the "knoppix" command. But I can't find the path to the command. Can somebody please help? thanks!
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
The analog thing modern open source, educational, low-cost analog computer
$800.00
Vintage 1960s Donner Model 3000 Analog Computer ~ MUSEUM PIECE Extremely Rare
$4000.00
Apple Macintosh SE/30 M5119 Computer 8MB RAM Recapped Working *See Description*
$475.00
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$229.00
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
Burr Brown Analog Computer parts Circuit boards w Helipot Potentiometers 1631a
$85.00
IBM Modem Saver Phone Line Tester
$7.99
Two (2) vintage The Analog Computing Pocket Reference Cards, 1985
$19.99
ACASIS PCIE Capture Card HDMI 1.4 1080P60HZ PCIE 2.0 X4 20Gbps for Video Capture
$248.99