I had problems with acessing my 4 40 GB IBM 60 GXP HD on the Promise Fasttrack 100 TX2 RAID controller.
I downloaded the fasttrack partial source 1.03.0.2 from www.promise.com
and compiled it as described in the readme. It works fine.
But for compiling the source you need also the kernel sources, etc.
Since the compiled module for Knoppix 3.3 is zipped only about 56KB I can e-mail it to everyone interested.
With the module 'FastTrack.o' available, copy it to a floppy disk
and reboot.
boot knoppix with following parameters:
knoppix dma modules-disk ide2=0 ide3=0 ide4=0 ide5=0 ide6=0 ide7=0 ide8=0 ide9=0
the kernel will ask you later for the modules-disk and the driver to load.
if you have a hd-installation of knoppix you should add the module to your initrd and add the boot parameters ide2=0 ide3=0 ide4=0 ide5=0 ide6=0 ide7=0 ide8=0 ide9=0 to your lilo.conf
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
Samsung 128GB (4x 32GB) M86B4G70DM0-CMA3 PC3-14900L 4Rx4 DDR3 ECC Reg Server Mem
$39.99
Samsung 16GB 2Rx4 PC4-2400 RDIMM DDR4-19200 ECC REG Registered Server Memory RAM
$20.99
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
Kingston KCP424SD8/16 16GB DDR4 2400Mhz Memory RAM
$15.00
BULK LOT OF 22 8GB 1Rx8 PC4-3200 DDR4 SO-DIMM SAMSUNG MICRON CRUCIAL MEMORY RAM
$299.00
M386A8K40BM2-CTD SAMSUNG 64GB (1X64GB) 4DRX4 PC4-2666V DDR4 SERVER MEMORY
$40.91
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96