LISa daemon autoconfigure script

**mkklavz** · 05-23-2004, 02:33 PM

the script itself should actually not be in the menu, it should rather be hidden and automatically run when network config changes.

**Suicide-King** · 05-31-2004, 12:42 AM

I have tried using both auto scripts for Lisa Deamon, i have tried smb and lan, and i have succesfully pinged every computer on my network. But everytime I try to connect to one of them i get this

Internal Error
Please send a full bug report at http://bugs.kde.org
Unknown error condition in stat: Network is unreachable

I go back to knosole to check the status of Lisa and get this
NetManager:

repare:bind (TCP) failed, errno: 98

Any help would be great

**ntsc** · 10-17-2004, 09:10 PM

Running Knoppix 3.4 installed to hard drive - Internet Browsing works fine, from console typing in lisa returns the same error message as the previous post

NetManager:

repare:bind (TCP) failed, errno: 98

Tried (I Think !!!!) to run the scripts as mentioned earlier and it just times out

Any help would be most welcome !

**ntsc** · 10-17-2004, 10:00 PM

Just to update:

Full power down of system - rebooted into KDE typed in lisa in console reported that it was working on some or other port (didn't make a note - too surprised that it was actually working !)

Tried Lineighbourhood - which did appear this time, only thing listed was "Knoppix", tried to browse the entire network (left username password as default) - no other PC's showing up (network is OK have two windows machines running which have no problem seeing shares on either)

Went back to console typed in lisa and got......

NetManager:

repare:bind (TCP) failed, errno: 98

**mikekgr** · 10-18-2004, 05:05 PM

Dear friend,
I had spend most of my time to browse window$ based network without success. If you have hd installation simply as root (in console) :

apt-get install komba2

Just when you adjust this samba client don't forget to specify your address range of your network e.x. 192.168.0.1 - 254

Best Regards,
Mike Kranidis