I'd like to see different screen aspect ratios supported in Knoppix. I have a Dell Inspiron 8500 with one of those 15.4" 16x10 ratio widescreens (I think Compaq and HP computers have them too), and I'd like to use the whole screen width with Knoppix.
1920x1200
1680x1050
1280x800
It would probably just take adding a couple lines to the XFree config file... I was going to wait until I found an example script with the necessary lines to add (again), but I can't seem to find them.
I bet there are a couple 16x9 screens out there too...
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MITS 8800 CPU Card 8080A S-100 S100 replica IMSAI CP/M
$35.00
$22.50
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00