Please post your /etc/lilo.conf
BTW, if you put Lilo on the Linux drive, don't you have to tell the bios to boot from that drive?
I am trying to do a knoppix hd install on an xp machine. I put in
a 2'nd hard drive so I could keep xp on its own disk. I formatted
the new drive as follows using cfdisk:
primary partition: 50 MB
logical: 3000MB
logical: 500MB
logical: 1000MB
I then did the knoppix install choosing to install lilo to partition instead
of master boot record. I created the boot disk. Rebooted computer
and when I select linux, or linux on hdb (i have 2 options for linux boot
on the menu - I assume they do the same thing) I get the following:
boot: Linux
Loading Linux
Error 0x07
Windows still boots ok with and without the boot disk.
Any help would be appreciated. I can cd to those directories on the
2'nd hard drive when I boot knoppix from the cd and it looks like
things were setup ok.
Brian
Please post your /etc/lilo.conf
BTW, if you put Lilo on the Linux drive, don't you have to tell the bios to boot from that drive?
I will have to wait until I get home to get the lilo.conf data.
I guess I was thinking if I am booting from the floppy I don't
have to tell the bios to boot from the hard drive - I thought that
was what the bootable floppy was for.
I do have one question - does the parition in which knoppix is
installed in have to be marked as bootable? I was thinking it
didn't if I was using the bootable floppy.
I did make one of the paritions on the 2'nd hard drive (where knoppix
is installed) bootable but there is nothing there currently - knoppix
was installed in the other partition.
Thanks for any info
Brian
Found the problem. I didn't realize this was really a lilo question.
Problem was new hard drive. Needed to turn on in bios. Thought
this was automagic since when I booted into windows (before
reformatting the drive) the drive showed up. :P
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00