have you found an solution?
you say you see grub, but (I havent used knoppix lately so I can be wrong) knoppix uses LILO nog grub. So what knoppix are you using? and you see grub, what exactly do you see?
Hi,
I am new to the Linux world and KNOPPIX was my first experience with Linux. I was impressed with it and tried to install it on my hdd. All went well until i reboot. I get to the prompt "GRUB" and then nothing happens. Can someone please help me out with this?
Thanks in advance
Cheers,
dantay
have you found an solution?
you say you see grub, but (I havent used knoppix lately so I can be wrong) knoppix uses LILO nog grub. So what knoppix are you using? and you see grub, what exactly do you see?
Hi superstoned,
That was what I thought too. I was baffled to see GRUB prompt greeting me. I THINK that I got over the initial problem I was having. I have had my hdd as the secondary master (there are no primary master or slave, my comp's interior is in a mess and ... I just got too lazy to move my hdd around) and after reading some of the postings, one of them pointed out that I could modify the lilo.conf. So I did and changed boot=/dev/hda to boot=/dev/hdc.
From then on, KNOPPIX loaded ... half way and I get some error message about bad CRC on my hdd and stops. I can't really remember the exact error message right now though. Therefore, I suspect there is something wrong with the hdd but I have been using it for some time and it works.
So, is what I did at the begining (altering the .conf file) the correct thing to do? Or would it have caused some CRC problem (??) to my hdd?
Thanks in advance.
well, its unlikely your disk is broken (or, part of it) but not impossible.
anyway, I'd start moving your hdisk to a propper place (e.g. primary master), it might help. I've seen alot of problems with these things too, esp with raid-hardware present in the system.
and what you did with the conf file is oke, it shouldnt give problems. but you have to re-run lilo for the new config to be applied (guess you did, it worked isnt it?)
Cisco (SG100D-05-UK) 5-Ports External Ethernet Switch
$40.00
HP Procurve 2824 24 Gigabit Ports 10/100/1000 External Managed Switch J4903A
$74.99
8 Ports Unmanaged Industrial Ethernet Switch Network Gigabit Ethernet Switch
$76.50
Cisco Meraki MS120-48LP 48 Port Blade Ethernet Switch UNCLAIMED
$349.98
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
HP Aruba 2530-8G-PoE+ 8x PoE+ RJ45 2x SFP Gigabit Switch J9774A No AC Adapter
$37.99