have you found an solution?
you say you see grub, but (I havent used knoppix lately so I can be wrong) knoppix uses LILO nog grub. So what knoppix are you using? and you see grub, what exactly do you see?
Hi,
I am new to the Linux world and KNOPPIX was my first experience with Linux. I was impressed with it and tried to install it on my hdd. All went well until i reboot. I get to the prompt "GRUB" and then nothing happens. Can someone please help me out with this?
Thanks in advance
Cheers,
dantay
have you found an solution?
you say you see grub, but (I havent used knoppix lately so I can be wrong) knoppix uses LILO nog grub. So what knoppix are you using? and you see grub, what exactly do you see?
Hi superstoned,
That was what I thought too. I was baffled to see GRUB prompt greeting me. I THINK that I got over the initial problem I was having. I have had my hdd as the secondary master (there are no primary master or slave, my comp's interior is in a mess and ... I just got too lazy to move my hdd around) and after reading some of the postings, one of them pointed out that I could modify the lilo.conf. So I did and changed boot=/dev/hda to boot=/dev/hdc.
From then on, KNOPPIX loaded ... half way and I get some error message about bad CRC on my hdd and stops. I can't really remember the exact error message right now though. Therefore, I suspect there is something wrong with the hdd but I have been using it for some time and it works.
So, is what I did at the begining (altering the .conf file) the correct thing to do? Or would it have caused some CRC problem (??) to my hdd?
Thanks in advance.
well, its unlikely your disk is broken (or, part of it) but not impossible.
anyway, I'd start moving your hdisk to a propper place (e.g. primary master), it might help. I've seen alot of problems with these things too, esp with raid-hardware present in the system.
and what you did with the conf file is oke, it shouldnt give problems. but you have to re-run lilo for the new config to be applied (guess you did, it worked isnt it?)
HP PROLIANT MICROSERVER MICRO SERVER HSTNS-5151 T4 Used.
$45.00
HP ProLiant Xeon E3-1220L V2 16 GB RAM 2.30 GHz MicroServer Gen8 NO DRIVES
$174.99
HPE PROLIANT MICROSERVER GEN10 PLUS MICRO TOWER SERVER - USED
$550.00
SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount
$202.49
HPE Proliant Microserver Gen10 X3421 Perf AMS, P03698-S01, 16GB Ram
$299.00
HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ*
$94.99
Supermicro Server Tower Xeon BOOTS E5-2620 v4 2.10GHz 64GB RAM NO HDD NO OS
$199.99
SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD
$90.00
1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE
$297.00
2U 12 Bay SAS3 SuperMicro Server 6028U-TR4T+ W/ X10DRU-i+ Barebone 12 Caddy RAIL
$299.00