Results 1 to 2 of 2

Thread: Knoppix loads runs but can't detect hard drive - Newbie help

  1. #1
    Junior Member
    Join Date
    Apr 2004
    Posts
    1

    Knoppix loads runs but can't detect hard drive - Newbie help

    I have a Toshiba Satellite laptop - I'm able to load knoppix - fully - but it doesn;t recognize my hard disk.

    I can run partition commander and see the drive - including using its browser to see each of the NTFS folders, filenames , dates and sizes. All looks ok there.

    I'm a total newbie to Linux/knoppix - it was amazing to see it autoload to the point I'm on the internet now on my laptop from knoppix - but minus my hard drive.

    from the command fdisk -l I do not see anything that says NTFS.

    A couple of times when I've been exiting knoppix, the (alomost) last message says - hda : lost interupt.

    Any suggestions?? please be as specific as possible as I'm not familiar with the commands.

    As requested, here is the info from the lspci -v command:

    thanks!! Randy

    knoppix@ttyp1[knoppix]$ lspci -v
    00:00.0 Host bridge: ALi Corporation M1644/M1644T Northbridge+Trident (rev 01)
    Flags: bus master, medium devsel, latency 0
    Memory at f0000000 (32-bit, prefetchable) [size=64M]
    Capabilities: <available only to root>

    00:01.0 PCI bridge: ALi Corporation PCI to AGP Controller (prog-if 00 [Normal decode])
    Flags: bus master, slow devsel, latency 0
    Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
    Memory behind bridge: f7f00000-fdffffff

    00:02.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) (prog-if 10 [OHCI])
    Subsystem: Toshiba America Info Systems: Unknown device 0004
    Flags: bus master, medium devsel, latency 64, IRQ 11
    Memory at f7eff000 (32-bit, non-prefetchable) [size=4K]
    Capabilities: <available only to root>

    00:04.0 IDE interface: ALi Corporation M5229 IDE (rev c3) (prog-if f0)
    Subsystem: Toshiba America Info Systems: Unknown device 0004
    Flags: bus master, medium devsel, latency 64
    I/O ports at eff0 [size=16]
    Capabilities: <available only to root>

    00:06.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link Controller Audio Device (rev 01)
    Subsystem: Toshiba America Info Systems: Unknown device 0001
    Flags: bus master, medium devsel, latency 64, IRQ 11
    I/O ports at 1000 [size=256]
    Memory at 10000000 (32-bit, non-prefetchable) [size=4K]
    Capabilities: <available only to root>

    00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV]
    Subsystem: Toshiba America Info Systems: Unknown device 0004
    Flags: bus master, medium devsel, latency 0
    Capabilities: <available only to root>

    00:08.0 Bridge: ALi Corporation M7101 PMU
    Subsystem: Toshiba America Info Systems: Unknown device 0001
    Flags: medium devsel

    00:0a.0 Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100] (rev 0d)
    Subsystem: Toshiba America Info Systems 8255x-based Ethernet Adapter (10/100)
    Flags: bus master, medium devsel, latency 64, IRQ 11
    Memory at f7efe000 (32-bit, non-prefetchable) [size=4K]
    I/O ports at ef40 [size=64]
    Memory at f7ec0000 (32-bit, non-prefetchable) [size=128K]
    Capabilities: <available only to root>

    00:11.0 CardBus bridge: Toshiba America Info Systems ToPIC95 PCI to Cardbus Bridge with ZV Support (rev 32)
    Subsystem: Toshiba America Info Systems: Unknown device 0001
    Flags: bus master, slow devsel, latency 168, IRQ 11
    Memory at 10001000 (32-bit, non-prefetchable) [size=4K]
    Bus: primary=00, secondary=03, subordinate=03, sec-latency=0
    Memory window 0: 10400000-107ff000 (prefetchable)
    Memory window 1: 10800000-10bff000
    I/O window 0: 00004000-000040ff
    I/O window 1: 00004400-000044ff
    16-bit legacy interface ports at 0001

    00:11.1 CardBus bridge: Toshiba America Info Systems ToPIC95 PCI to Cardbus Bridge with ZV Support (rev 32)
    Subsystem: Toshiba America Info Systems: Unknown device 0001
    Flags: bus master, slow devsel, latency 168, IRQ 11
    Memory at 10002000 (32-bit, non-prefetchable) [size=4K]
    Bus: primary=00, secondary=04, subordinate=04, sec-latency=0
    Memory window 0: 10c00000-10fff000 (prefetchable)
    Memory window 1: 11000000-113ff000
    I/O window 0: 00004800-000048ff
    I/O window 1: 00004c00-00004cff
    16-bit legacy interface ports at 0001

    01:00.0 VGA compatible controller: Trident Microsystems CyberBlade XPAi1 (rev 82) (prog-if 00 [VGA])
    Subsystem: Toshiba America Info Systems: Unknown device 0001
    Flags: bus master, 66Mhz, medium devsel, latency 8, IRQ 11
    Memory at fc000000 (32-bit, non-prefetchable) [size=32M]
    Memory at fbc00000 (32-bit, non-prefetchable) [size=4M]
    Memory at f8000000 (32-bit, non-prefetchable) [size=32M]
    Memory at f7ff8000 (32-bit, non-prefetchable) [size=32K]
    Expansion ROM at <unassigned> [disabled] [size=64K]
    Capabilities: <available only to root>

    log off

  2. #2
    Senior Member registered user
    Join Date
    Mar 2003
    Location
    colorado springs, colorado
    Posts
    1,933
    Did you try fdisk -l /dev/hda

    Also since Knoppix automatically creates mount points for any partitions it sees you could do

    ls -l /mnt

Similar Threads

  1. 3.8.2 and external usb hard drive( Newbie help)
    By grakem in forum Hardware & Booting
    Replies: 0
    Last Post: 06-01-2005, 04:52 PM
  2. Problem detect/mount dvd drive force to switch back to WinXP
    By wilson001 in forum Hardware & Booting
    Replies: 4
    Last Post: 12-21-2004, 11:17 PM
  3. New Newbie !! How to make an ISO which runs ???
    By Juste in forum Customising & Remastering
    Replies: 2
    Last Post: 09-22-2004, 09:51 AM
  4. Can I mount a 2nd hard disk if BIOS can't detect it?
    By Blisset in forum Hardware & Booting
    Replies: 4
    Last Post: 09-17-2004, 06:50 PM
  5. Newbie - Won't Detect PCI Ethernet Card
    By ti83programmer in forum Hardware & Booting
    Replies: 9
    Last Post: 06-28-2003, 04:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE picture

1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE

$297.00



HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVES picture

HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVES

$199.99



HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server - 1 x Intel Xeon picture

HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server - 1 x Intel Xeon

$846.19



HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ* picture

HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ*

$94.99



HP ProLiant Xeon E3-1220L V2 2.30 GHz 16 GB RAM MicroServer Gen8 NO DRIVES picture

HP ProLiant Xeon E3-1220L V2 2.30 GHz 16 GB RAM MicroServer Gen8 NO DRIVES

$199.99



HPE ProLiant MicroServer Gen8 Intel Xeon E3-1265L 16GB ECC PCIe x16 4x1TB HDD picture

HPE ProLiant MicroServer Gen8 Intel Xeon E3-1265L 16GB ECC PCIe x16 4x1TB HDD

$249.99



SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount picture

SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount

$202.49



Supermicro 5018A-FTN4 Rack Server - Black picture

Supermicro 5018A-FTN4 Rack Server - Black

$125.00



SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD picture

SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD

$90.00



1U Supermicro Server X10DRU-i+ 2x Xeon E5-2690 V4 28 Cores 64GB 4x 10GBE-T 2PS picture

1U Supermicro Server X10DRU-i+ 2x Xeon E5-2690 V4 28 Cores 64GB 4x 10GBE-T 2PS

$324.00